JVC TV 13140 - Manual (Page 5)

PRECAUTIONS
MOISTURE CONDENSATION
DO NOT OPERATE ANY FUNCTIONS ON THIS UNIT FOR AT LEAST TWO OR
THREE HOURS WHEN MOISTURE IN THE AIR CONDENSES ON IT. LET THE
UNIT STAND WITH POWER ON (SEE BELOW).
■ WHAT IS MOISTURE CONDENSATION?
Wven a cold liquid is poured into a giass, for example, water vapor in the air will
condense on the surface of the glass. This is called moisture condensation. .
■ MOISTURE WILL CONDENSE ON THE UNIT IN THE FOLLOWING CASES;
• When you move the unit from a cold to a wann place.
• After heating a coid room or under extremely humid conditions.
■ WHEN YOU EXPERIENCE THE ABOVE CONDITIONS,
Plug the power cord into an AC outlet, set the POWER switch to ON and leave the
unit at room tentpeiature until moislure condensation disappears,
Depending on the surrounding conditions, this may take two or three hours.
Weo Tape
Do not insert fingers or any other objects into the
cassette loading slot Do not spray cleaner or wax
directly on the unit or use forc^ air to remove dust
If you cause a static discharge when touching the
unit, and the unit fails to function, simply unplug the
unit from the wall outlet, wait a few minutes, and
plug it back in. The unit should return to normal
operation.
Do not place the unit on or near appliances which
may cause electromagnetic interference (e.g.
speakers, etc). Doing so may cause erratic operation
0 # the unit irxdixjing picture and/or sound distortion or
noise.
Keep the unit away from flower vases, sinks, etc. If
liquids should be spilled info the unit, serious
damage will result, if you spill any liquids into №e
unit, unplug the AC power cord Immediately and
consult qualified service personnel before attempting
to use it again.
When you leave your home for a long time, unplug
the AC power cord.
Avoid places subject to strong vibration. Use in a
horizontal (flat) position only.
When you finish operating the unit, always unload
the cassette and turn off the power.
To protect the unit from a lightning storm, unplug the
AC power cord from the wall outlet and disconnect
the antenna.
POWER SOURCE
The ventilation holes prevent overheating. Do not
block or cover these holes. Especially avoid
covering the holes with soft rnaterials such as doth
or paper.
_,
It’
I
У V,
WIDER HOLE
AND BLADE
Polarized AC Coid
{One blade is wider than the other.)
TO USE AC POWER SOURCE
Use the AC polarized line cord provided for operation on AC. Insert
the AC cord plug into a standard 120V $0Hz polarized AC outlet.
NOTE:
1 . Never connect the AC line cord plug to other than the specified
voltage (120V 60Hz). Use the attached power cord only.
2. If the polarized AC cord does not lit into a non~polarized AC
outlet, do not attempt to file or cut the blade. It is the user’s
responsibility to have an electrician replace the obsolete outlet
3. If you cause a static discharge when touching the unit, and the
unit fails to function, simply unplug the unit, from the AC outlet,
waH an hour, and plug it back in. The unit should return to normal
operation.
СЛ