CLEAR 4G+ Personal Hotspot Users Guide - Manual (Page 5)

4
Set It Up (continued)
Insert and Charge the Battery
The battery comes partially charged, so you can use your CLEAR Spot right away.
The CLEAR Spot battery is easy to charge.
You can use the CLEAR Spot while charging the battery.
When the battery is fully charged, you’ll see four bars on the LCD screen.
It takes approximately three hours to fully charge a battery that has no charge.
The LCD screen displays icons, depending on the battery charge level. The chart below illustrates
the icons, as well as the descriptions of the different battery conditions.
Icon Description
The battery charge level is critical and the battery should be charged immediately. When this
happens, the CLEAR Spot automatically will turn off.
No battery is in the CLEAR Spot. The CLEAR Spot is connected to the Wall Charger.
The CLEAR Spot is connected via the USB Cable. The battery is either charging or not
inserted.
The battery is low.
Four bars indicate the battery is fully charged.
When charging, the LCD screen shows and, if the CLEAR Spot is off, displays a message
“Charging… xx% complete.”
To use the Wall Charger, plug the small end of the
Micro-USB Cable (USB Cable) into the CLEAR
Spot, plug the large end into the Wall Charger, and
plug the Wall Charger into an electrical outlet .
To charge the CLEAR Spot battery through your
computer, plug the small end of the USB Cable
into the CLEAR Spot, and plug the large end into
an available USB Port on your computer .
Remove the battery cover, slide in the battery so the pins
align, and replace the battery cover.
.