EcoTech Marine Full EcoSmart - Manual (Page 25)

Operational Modes
25
Once you have entered into
Short Pulse Mode, adjust
the speed to your desired
intensity then tap Set. Now,
typically you would tune the
frequency of your pulse but if
you would like to enable the
Auto-Tune function, hold Set
and Option until the LED’s
roll back and forth. The
EcoSmart driver will now
start at the highest pulse fre-
quency, then slowly move to
slower and slower frequen-
cies. Once you see your desired wave form in your aquarium, tap Set again to stop the Auto-Tune.
You will now have the ability to fine-tune your wave form by pressing Mode to go back one step, or
Option to go forward one step. This will be shown visually on the LED strip. Once you are happy
with the wave form that you have created, press Set again to save it. You will know it is saved be-
cause the LED knob will breath blue.
Wave Motion Warning
The generation of waves within your aquarium places additional stress on the aquarium glass and
joints. Not all aquarium tanks are designed to withstand this stress, and failure of the glass and/
or joints could result. You are encouraged, before generating waves, to consult with your aquarium
tank manufacturer to determine if the tank construction is adequate to withstand the additional
stress generated by the wave motion. You are also encouraged to assure that your aquarium stand
or furniture is adequately stable to withstand the additional stress resulting from wave generation.
EcoTech Marine DISCLAIMS AND WILL NOT BE LIABLE FOR, damage to aquarium tanks or their
surroundings, water damage, or any other consequential damages resulting from wave generation.
MAKE WAVES AT YOUR OWN RISK.
(Hold to save,
press to access
saved wave)
Set
Short Pulse
Freq. Set
Saved
Wave
Set
Set
Option
/Pwr
Auto-Tune
Hold Set and Option
until Blue LEDs roll back
and forth slowly
Press Set when you
see a desired wave
form in your tank.
To fine tune wave, press the mode to speed
up wave and option to slow down wave. This
will be shown visually with the blue LED strip.
When satisfied, press Set again to save wave.
Option
/Pwr
Press Press
Mode
Set
Press
Auto-Tune
With the new EcoSmart driver, making a wave form in your tank is made easy with Auto-Tune
functionality. Follow the sequence outlined in the diagram below to utilize the Auto-Tune function in
simulating a wave in your reef tank environment.
Section 4.3