Mac 10, Fan filter unit – Envirco MAC 10 IQ User Manual
Page 10
MAC 10
®
IQ
Fan Filter Unit
10
Innovators in Clean Air Technology | www.envirco.com | Operation & Maintenance
I n s t a l l a t i o n & S e r v i c e M a n u a l
ELECTRICAL SPECIFICATIONS
Control and Interface Signals:
1. External Speed 0-10V Input
•
Input impedance 20k Ohms.
•
MIN ON-to-OFF threshold: 190mV
•
MAX OFF-to-ON threshold: 240mV
•
ON (~215mV) to 9.89V linearly scales 1 to 99% speed.
•
9.89V or more deadbands to 100% speed.
2. External LED Output
•
10mA regulated
•
LED forward voltages up to 5V
3. RPM Signal
•
Signal Value: mVDC = RPM
•
Ex: 900mV = 900RPM
•
RPM Output Range: ~ 0, 5 to 2000 RPM (0, 5mV to 2000 mV DC)
•
RPM Output Resolution: 5RPM (Zero, 400 steps from 5 to 2000 RPM inclusive)
Electrical and Environmental Specifications:
Specification
Min
Typical
Max
Units
Input Voltage
22
24
42
VAC
Supply Frequency
50
50/60
60
Hz
Input Power Consumption
na
na
0.5
VA
Ambient Operating Temperature
0
25
50
C
Test Probe JacksPoints:
The test probe jacks may be used to measure the motor rpm or the PWM signal that is being output to the motor.
•
In Manual or Analog Control Mode with a S2 address setting of 1 or greater, the test probe jacks output 0-2000 mVDC rep-
resenting motor RPM. By changing the address S2 switch to 0, the test probe jacks will output 0-1000 mVDC representing
0-100% demand signal to the motor. The address may be changed without interrupting power to the control card.
•
In Network Control Mode, 0-2000 mVDC always represents RPM.
LED Indicators:
•
Onboard Status LED:
The Onboard Status LED is software controlled by the unit microcontroller. The Status LED is solid ON when RPM reported by
the motor is greater than zero and OFF when RPM reported by the motor is zero.
•
External Status LED:
Support for an external Status LED (10mA current-controlled driver), via a 2-pin MTA connector, for remote system status notifi-
cation. The external Status LED operates in the same manner as the Onboard Status LED.
•
Onboard Net LED:
The Onboard Net LED is driven directly by the receive data signal. The NET LED shows all network traffic on a 2-wire network.
The NET LED is intended to confirm low-level network connectivity, independent of microcontroller or firmware functionality. If
A/B network wires are swapped, the NET LED will be normally on, providing quick diagnostics of this common condition.
RJ45 Network Cable Connections:
1
2
3
4
5
6
7
8
Bus Power
Pass Through
0V (GND)
RS-485
0V (GND)
Bus Power
Pass Through
+
NC
NC
-
Net LED Status Definition
LED OFF
Power Lost or No Communications
LED Flickering Network Data Traffic In Progress
LED ON
A/B network wires are swapped
Red Network LED
Green Status LED