Futaba 9VHP User Manual
Page 19
Trim Memory
1) After the model is "trimmed out" and flying
well, land and select the TRIM screen.
2) Move the cursor to the TRIM-MEMORY line
and press the
program key. A message
of the TRIM screen should then be equal to
those displayed before pressing the yes key.
will be displayed asking if the trim data is to
be renewed. Press the
program key. All
trim positions are then "memorized" by the
computer.
3) All trim levers featuring Trim Memory can
then be returned to their neutral positions.
When the AIL, ELEV, RUD, and THR Trim
Levers are moved to their neutral positions, a
softer "click" will be felt. When a knob or sub
trimmer is moved slowly to the neutral posi-
tion, a tone will sound indicating the electrical
neutral. Positions displayed on the POSI line
<Trim Memory Trimmers>
a) Control Stick Trim (Except ATL trim)
b) Eight sub trimmers on the trimmer
panel
c) REV MIX UP and DN Knobs
d) IDLE-UP 1 and 2 Knobs
e) Hovering Pitch and High Pitch Trim
Levers
f) Hovering Throttle Knob
g) Pitch Trim (when activated)
[45]