Futaba 9VHP - Manual (Page 22)

ADJUSTMENTS AND FLIGHT TECHNIQUES
Model Copy Function
• The Copy function allows the programmed
data and trim positions for one model to be
duplicated in their entirety on another pro-
gram (model) number. As an example, let's
suppose that Aircraft No. 1 is properly-trim-
med and flys well, but you wish to experiment
with a different mixing or trim setting. The
Model No. 1 data can be copied onto the
Model No. 2 program. You can then make the
experimental trim modification on the Model
No. 2 program only. The original settings will
be retained as is, on the No. 1 program. The
MODEL SELECT function can then be used
to easily switch back and forth between the
old and new setting for comparison (although
not in-flight).
• As another alternative, settings for a given
model could be copied on two or more pro-
grams with modifications for different weather
conditions, maneuver schedules, etc.
yes
Setting Method
1) Perform the Model Select function to select
the Model No. that you wish to copy.
2) Move the cursor to the program No. that you
wish to copy the data onto, and press the
program key.
3) A message will appear asking if the data is to
be copied, (in the example shown, the Model
No. 1 data is to be copied to the Model No. 2
program slot.)
4) Press the key to execute the copy func-
tion or the key to cancel.
NOTE: Perform the TRIM MEMORY function
before copying. The trim levers can then be set
to the neutral position.
[48]