Futaba 9VHP User Manual
Page 24
ADJUSTMENTS AND FLIGHT TECHNIQUES
SERVO (Transmitter Test Mode)
Transmitter control movements are shown on a bar graph representing servo movement for
channels 1 through 8. The center of the graph is the neutral position. The bottom half in-
dicates counterclockwise servo rotation and the top half represents clockwise rotation.
Setting Method
1) Select the EDIT screen and move the cursor
to Line 3 with the
cursor key, then dis-
play the SERVO screen by pressing the
program key.
2) Bar graphs proportional to the servo throw
can be observed by operating the control
sticks, levers, and switches of each channel of
the transmitter (1 to 8).This can be used to test
the performance of the transmitter, and check
the effect of new settings and data inputs.
RESET
The RESET function can be used to return programmed data to the original factory set-
tings. Certain functions can be reset individually (Items 1 through 7 below), or all data can
be reset in a single operation (Item 8).
Functions to be Reset:
1. REV, F/S 3. A F R
5. MIX 7. PAR
2. ATV 4. D/R, EXP 6. TRM 8. ALL
ALL resets Items 1 through 7 simultaneously.
the program
key.
2) Move the cursor to the Item No. to be reset
with the
3) Press the
program key. A message will
cursor keys.
appear asking if the data is to be reset.
Setting Method
1) Select the EDIT screen and move the cursor
to Line 3 with the
cursor key, then press
4) To complete the RESET operation, press the
program key. To cancel the operation,
press the
key.
[50]