Futaba GV-1 - Manual (Page 24)

FUNCTIONS
Initial setting for governor operation
When using the governor for the first time, or when the throttle linkage or the
fuselage was changed, always perform this initial setting. The set data are
saved even when the power is turned off.
Throttle limit setting
(Governor idle/high/stop points setting)
1
Call the "limit set" screen with the
FUNC+ or FUNC- key.
2
Set the throttle stick to the maximum slow position
and press the DATA+ or DATA- key.
The "Idle" display stops flashing and changes to a steady light and
the idle point is memorized.
3
Set the throttle stick to the full high position and
press the DATA+ or DATA- key.
The "High" display stops flashing and changes to a steady light and
the high point is memorized.
4
Set the throttle stick to the engine cut position and
press the DATA+ or DATA- key.
The "Stop" display stops flashing and changes to a steady light and
the stop point is memorized.
Setting error display
-Set the servo travel to ATV50% or more. If the servo travel is set to less
than 50%, "-ERR-" will be displayed. Increase the servo travel and reset
the throttle linkage. (Note: The closer to 100% ATV is the best condition)
-Always set the stop point to a position lower than the idle point. If the stop
point is set to a position higher than the idle point, "-ERR-" will be dis-
played. If this occurs, set the stop point to a position lower than the idle
point and reset the throttle limit.