Futaba GV-1 - Manual (Page 28)

FUNCTIONS
C. When linked with throttle stick
(When there is no vacant channel)
1
Call the "governor on/off stick op-
eration set-up" screen with the
FUNC+ or FUNC- key.
2
Switch the display from INH to on/off with the
DATA+ or DATA- key.
When the stick switch is operated, the display switches from
"off" to "on" and the switching point can be checked.
3
When the throttle stick is set 15% or less from the
slow side, the governor is turned on.
Until the start of flight, keep the governor in the off state
with the throttle stick at 15% or less from the slow side.
This is the engine starting, etc. mode. If the throttle stick is set to the ON position
when the engine speeds exceeds 70% of the set speed, the governor will be
unintentionally turned on.
Battery fail safe setting
Always perform battery fail safe setting at the governor.
When used, the governor controls the throttle. Therefore, the battery fail safe
function normally set in a PCM transmitter is not performed.