Futaba GV-1 - Manual (Page 29)

FUNCTIONS
1
Call the "battery fail safe" screen
with the FUNC+ or FUNC- key.
2
Set the battery fail safe window to
"ACT" with the DATA+ or DATA-
key.
3
Call the "battery fail safe position"
w i n d o w w i t h t h e F U N C + o r
FUNC- key.
4
Set the throttle stick to the desired position and
press the DATA+ or DATA- key.
5
The battery fail safe position is memorized.
When the throttle stick is operated, "*" is displayed at the set
position and the set position can be verified.
Set the throttle channel fail safe function as described be-
low.
When used, the governor controls the throttle. Therefore, the throttle channel
fail safe function normally set in a PCM transmitter is not performed.
Fail safe data setting
Transmitter side setting
Use the fail safe function of the channel that turns the governor on and off
to set the fail safe position to the point at which the governor is turned off.
With this setting, when the system enters the fail safe state, the governor is
turned off and the receiver throttle signal is output directly.