Entry codes, Access cards, Entry codes access cards – Chamberlain EL25 User Manual
Page 21
Page 20
Entry Codes
Access Cards
1 Press
2 Enter Entry Code (3-9 digits). Then (
#
)
Factory Setting for Entry Code Length is 4 digits
See
“Entry Code Length” above.
Add an Entry Code
ONLY. For adding or editing full function Entry Codes (i.e., codes with additional options
such as use schedules, door assignments, etc.).
Note: A basic Entry Code will be active with the current date, time and never deactivates, unlock all controlled
doors, with no time constraint (i.e., can be used 24 hours a day, 7 days a week).
Example:
Each assigned Entry Code must be entered with the set amount of allowable digits (3-9). For example, if
you assign “4578” as a resident's Entry Code, but the system is set for 5 digits, the visitor will have to enter
“04578” to enter the building.
When adding entry codes, note the following:
Adds Entry Code “5400”.
Then
Entr
y Codes / Access Cards
Entr
y Codes / Access Cards
50
Add a Basic Entry Code:
2
1
Note:
1 Press
2 Enter Card Number (1-65534). Then (
#
)
3 Enter Facility Code (0-63 or 0-255, depending on the card type). Then (
#
)
4 Enter Card Type (26 or 30). Then (
#
)
This programming step allows you to add a card using the card's number. For adding or editing full function
cards (i.e., cards with additional options such as use schedules, door assignments, etc.).
Notes: A basic card will be active with the current system time and never deactivate, unlock all doors connected
to the EL25, with no time constraint (i.e., can be used 24 hours a day, 7 days a week).
For new records, if you don't add a Facility Code or Card Type, the system will add the defined default values.
•
•
–
–
Example:
If you don't add a facility code or card type, the system will assign the default. The allowable facility code
range is 0-255 for 26-bit cards and 0-63 for 30-bit cards.
When entering cards with facility codes:
When adding cards, note the following:
Adds card with number “34432”, default Facility Code and 30-bit Card Type.
Then
Enter the facility codes individually when adding cards
OR
Enter a default facility code. If you don't, the card will be assigned the default facility code.
3
4
Add a Basic Card:
80
1
2
Required Step
Optional Step,
Press (
#
) to Skip.
If you make an error during an entry, press the asterisk key (
*
) to begin again.