Chamberlain EL25 - Manual (Page 8)

Page 7
Enter Programming Mode
Exit Programming Mode
1 Press
2 Enter the (6) six-digit password. The default is six zeroes.
If you will be programming the unit via modem, please refer to the Versa XS online help.
After entering programming mode for the first time, we suggest you change
the password to maintain the security of your system. Important:
The unit is now ready to accept programming instructions!
1 When you hear the dial tone, press
If multiple EL25 units are sharing the same phone line, then a Unit ID Code (1-7) will need
to be entered at this time.
1 Dial the unit's phone number.
2 When the EL25 picks up the call, you will hear 2 beeps.
3 Press
The unit is now ready to accept programming instructions!
1A
3A If multiple EL25 units are sharing the same phone line, then a Unit ID Code (1-7) will need
to be entered at this time.
2 Enter the (6) six-digit password. The default is six zeroes.
3 Press and the tone will stop.
The unit is now ready to accept programming instructions!
4 Enter the (6) six-digit password. The default is six zeroes.
5 Press
Press on the EL25 keypad and the unit will respond with 3 short beeps when disconnecting.
Press on the telephone and the unit will respond with 3 short beeps when disconnecting.
and the beeps will stop.
Note: If the EL25 and an answering machine (or answering service) utilize the same phone line, let the line
ring at least (2) two times, hang-up, and call back within one (1) minute. The EL25 will answer on the
second call. If the unit does not answer, you may need to change the ring count.
Press when using a telephone or the EL25 to cancel
programming sequence and exit programming mode.
•
•
Programming Single Unit Over
view
Programming Single Unit Over
view
0
***
From the Remote Telephone:
From the Residence Telephone:
From the EL25 Keypad:
2 Short Beeps
1
2
2