Haltech E6S User Manual
Page 116
116
IF USING A RELUCTOR PICK-UP DEVICE FOR THE TRIGGER (MAIN IGNITION
EVENT) SIGNAL, SET BOTH SWITCHES A AND B DOWN.
NOTE: The TRIGGER EDGE on the IGNITION SET-UP page must be set to RISING.
IF USING A RELUCTOR PICK-UP DEVICE FOR THE HOME (SYNC. EVENT)
SIGNAL, SET BOTH SWITCHES C AND D DOWN.
NOTE: The HOME EDGE on the IGNITION SET-UP page must be set to RISING.
DO NOT ACTIVATE ANY OF THE SWITCHES UNLESS YOUR INSTALLATION
REQUIRES YOU TO DO SO.
+ V
ZERO
(GND)
- V
TRIGGER POINT IS RISING EDGE
ZERO VOLT CROSSING
TRIGGER
SIGNAL
Figure E.5. Top diagram is the signal from the magnetic reluctor sensor. Bottom diagram is
the signal after modification by the on-board Reluctor Adapter circuit.