E.2.3 adjusting the on-board jumpers – Haltech E6S User Manual
Page 118
Advertising
118
Output Signal from the Motronic Sensor
Zero Volts
(Ground)
Output Signal
Zero Volts
(Ground)
If the wires are reversed and the signal goes negative (-) first, or a rising edge is selected to
trigger the Haltech ECU, then the on-board reluctor adapter will still generate a pulse but it
will not trigger the Haltech correctly resulting in incorrect ignition timing. So please make
sure it is wired correctly.
E.2.3 Adjusting The On-Board Jumpers
•
Remove the 4 phillips head screws from the endplate opposite to the main connector.
•
Slide the lid off the enclosure.
JUMPER LOCATIONS
JUMPERS
DIP SWITCHES
MAIN CONNECTOR
J11
J10
J6
J7
J8
J9
J5
A
B
C
D
E
F
J2
J4
J1
J3
Advertising