Carrier V2203-DI (26--00128) - Manual (Page 30)

2--4 62--11362
2.2.3 Cylinder Head And Valves (Continued)
3
4
1. Rocker Arm Bracket
Mounting Bolt
2. Rocker Arm Assembly
3. Push Rod
4. Tappet
2.2.3.c Nozzle Holder Assembly
1. Remove the overflow pipe assembly.
2. Remove the nozzle holder assemblies (1).
When Reassembling
Replace the copper gasket with a new one.
Tightening
Torque
Nozzle Holder
Assembly
26 to 29 N . m
2.6 to 3.0 kgf . m
19 to 21 ft--lbs
Overflow Pipe
Assembly
Retaining Bolt
9.81 to 11.2 N . m
1.00 to 1.15 kgf . m
7.24 to 8.31 ft--lbs
2.2.3.d Rocker Arm and Push Rod
1. Remove the rocker arm bracket mounting bolts (1).
2. Detach the rocker arm assembly (2).
3. Remove the push rods (3).
When Reassembling
When putting the push rods (3) onto the tappets (4),
check to see if the push rod end is properly seated in the
tappet dimples.
NOTE
After instaling the rocker arm, be sure to adjust
the valve clearance. (Refer to Section 1.8.7)
Tightening
Torque
Rocker Arm
Bracket Mounting
Bolt
24 to 27 N . m
2.4 to 2.8 kgf . m
18 to 20 ft--lbs