Carrier V2203-DI (26--00128) - Manual (Page 34)

2--8 62--11362
2.2.4 Injection Pump and Gear Case (Continued)
2.2.4.b Governor Springs and Speed Control Plate
(Continued)
When Reassembling
NOTE
A length of string passed thru the governor
spring can be used to retrieve the spring if it un-
hooks from both the specific tool and the speed
control plate.
Begin reassembly by inserting the specific tool (1) thru
the injection pump cover opening thru to the speed
control plate opening.
1. Using the specific tool (1), capture the governor
spring (5) and speed control plate (7) assembly.
2. Pull the governor spring (5) / speed control plate (7)
assembly thru and secure it to the fork lever (2).
3. Seat and assemble the speed control (5) plate with
two bolts and two nuts to the gear case.
4. Check the movement of the speed control lever (4).
NOTE
The speed control lever (6) must be free to
move from low idle position to maximum speed
position and should always return to the high
idle position.
5. Finally, install the injection pump cover to the gear
case.
1. Specific Tool
2. Fork Lever
3. Speed Control Plate
Mounting Nut
4. Speed Control Plate
Mounting Bolt
5. Large Governor Spring
6. Speed Control Lever
7. Speed Control Plate