CFM Corporation ODSHR42 - Manual (Page 20)

20
ODSHR Outdoor Woodburning Fireplace
20002264
The following accessories for this appliance are available from your local CFM Corporation products distributor.
Should you need additional information beyond what your distributor can furnish, contact: CFM Corporation, 2695
Meadowvale Blvd., Mississauga, Ontario, Canada L5N 8A3, Attn: Technical Services.
CAUTION: This fireplace and chimney assembly is a highly engineered system, and, as such, must be oper-
ated only with CFM Corporation approved components. If you use an unapproved component to make any
modifications, you may create a possible fire hazard and will void the CFM Corporation warranty. In addition,
such action may void the coverage provided by the owner’s insurance.
Accessories
Description
Designed to enclose the fireplace opening
with glass doors allowing the fire to remain
visible. Available in Polished, Brushed
Brass, Black, Stainless Steel and Pewter
Provides outside air for fuel conbustion
in the firebox. This accessory must be
installed before fireplace is installed.
Located on the floor in front of fireplace
to protect the floor from heat, hot embers,
ashes, etc.
Used to patch cracks in hearth.
Used to protect walls adjacent to the fire-
place.
Required at each floor level and attic on
multi-story installation.
Used to support the chimney at each 30
feet of vertical height above the hearth and
at every 6 feet of inclined chimney run.
Each support adds 2¹⁄₂" to chimney length.
Accessory
Glass Enclosure Kit
Outside Air Kit
Hearth Extension
Hearth Patching Kit
Wall Shield
Firestop
Chimney Support
Contemporary Flashing
Contemporary Chase Top Termina-
tion
Contemporary Round Top Termina-
tion
Model No.
42SHGDKDP/BB/BK/SS/S
AK-MST
EH2416
HPC1
SP40
FS2A (straight flue)
FS6A (30° inclined flue)
11CS (11" flue)
Required for contemporary top termination
on the roof to prevent rain entry.
Used to terminate chimney at the top of a
chase. Adapter kit is included, flashing is
not included.
For use with Type "11CF" Chimney Sys-
tems.
Used to terminate chimney on the roof.
Flashing not included.
8-6-12
(0 to 6/12 pitch)
8-12-12
(6/12 to 12/12 pitch)
SLTCF11
RLTCF11