Vertical Communications TeleVantage 7.5 - Manual (Page 100)

7-28 I NSTALLING I NTEL T ELEPHONY C OMPONENTS
Configuring Internet telephony boards
Perform the steps in this section only if you have one or more Internet telephony boards
installed.
Specifying the IP address, subnet mask, and gateway IP address
For each DM/IPx board, perform the following steps:
1. Start the Intel Dialogic Configuration Manager (DCM) if it is not already running. See
See Appendix D, “Using the Intel Dialogic Configuration Manager” for instructions.
2. In the DCM main dialog box, double-click the first IP telephony board.
3. Click the Network tab.
4. Complete the following required fields. See your network or system administrator for
the values to enter.
Q For IPAddress , enter the static IP address assigned to the network interface card
(NIC) attached to the Internet telephony board.
Q For SubnetMask , enter the network’s subnet mask.
Q For GatewayIPAddress , enter the IP address of your router.
5. Click OK .
6. Repeat for each additional IP telephony board.
If you have digital station boards, go to the next section. Otherwise, perform any other required
board-specific configuration steps described in the table on page 7-19. When you are done, go
to “Test-starting the Intel Dialogic drivers” on page 7-33.