Vertical Communications TeleVantage 7.5 - Manual (Page 90)

7-18 I NSTALLING I NTEL T ELEPHONY C OMPONENTS
3. Select the parameter Derive Primary Clock From (User Defined) and then select a
FrontEnd_x value from the Value drop-down list that corresponds to the span that is
connected to the telephone company. For example, if the first span is the one that is
connected, select
FrontEnd_1 .
4. Click OK .
Go to the next section.
Configuring boards for use outside of North America or Japan
If you are located in North America or Japan, go to “Board-specific configuration tasks” on
page 7-19.
If you are located outside North America and Japan, you must configure all your Intel Dialogic
boards to use the a-law audio format.
Important: You use DCM to specify the a-law format for all boards except for DSIx boards. You
use the Intel MEA Configuration program to specify the a-law format for DSIx boards.
To specify a-law format for all boards except DSIx boards
1. In the DCM main dialog box, under TDM Bus, double click Bus-0 .
2. Select Media Type (User Defined) from the list.
3. Select ALaw from the Value drop-down list.
4. Click OK .
Note: During the TeleVantage Server installation, which is described in Chapter 9 in
Installing TeleVantage, you will choose your voice files format and your country.