Interlogix Simon XT User Manual - Manual (Page 33)

Simon XT User Manual 27
Special chime
To enable or disable the Special chime feature:
1. Scroll up/down until the display shows Chime.
2. Press Enter. The current setting will flash.
3. Scroll up/down to toggle Special chime on/off.
4. Press Enter. The setting will stop flashing.
5. Press STATUS to exit.
An outlined bell icon will appear in the display when Special chime is enabled.
Note: This menu will not appear if Special chime sensors are not in your system.
System tests
This menu lets you run sensor and communication tests, and initiate a phone call
from the panel to the Enterprise Downloader. For more information, see
“Testing”
on page 35.
This menu item is a read-
only display of the system’s firmware version. Press
Status to exit.
Contrast
To adjust the Contrast of the display, do the following:
1. Scroll up/down to Contrast.
2. Press Enter.
3. Scroll up/down to increase and decrease the contrast setting. (There are
eleven contrast levels.)
4. Press STATUS to save the setting and exit.
Note: Changes in contrast are more noticeable when not looking at the display
straight on.
System programming
To enter system programming mode, do the following:
1. Enter the system menu.
2. Scroll up/down to System programming, then press Enter.
3. The panel displays Enter code.
4. Enter your master code, then press Enter.
At this point, you are in the System programming submenu. At this level, the
following items are accessible: