Code Alarm SRT 9000 - Manual (Page 16)

16
Using Valet Mode
Using Valet Mode
To engage valet mode:
1. Turn the ignition key to the ON position.
2. Press and hold the emergency override button.
3. The blue dashboard mounted LED will light solid
indicating that the system is in valet mode.
When valet mode is activated the dash mounted status LED will light
solid, and all security functions will be disabled.
To disengage valet mode:
1. Turn the ignition key to the ON position.
2. Press and hold the emergency override button.
3. The blue dashboard mounted LED will turn off indicating
that the system has exited valet mode.
When the valet mode has been deactivated the dash mounted status
LED will turn off and all security functions will be enabled the next time the system is armed.
VALET OFF:
SECURITY ON
Using Your Remote Vehicle Starter
Remote Starting Your Vehicle
To activate the remote vehicle start function, press and release the STAR button on the remote control 2 times
within 2 seconds. The system will sound, the parking lights will flash 1 time and the system will check the vehicle
to ensure it is safe to start, if all safety parameters are correct, the vehicle will start within 10 seconds (diesel
vehicles will take longer). The vehicle’s parking lights will turn on (or flash depending on system settings) as a
visual indication that the vehicle has started and is running. Press and release the STAR button on the remote
control 2 times within 2 seconds again to turn the vehicle off.
If your vehicle stalls or does not start, the system will pause 3 seconds, then try 2 more times to start the vehicle (a
total of 3 attempts). The system will pause 3 seconds between each start attempt. If the vehicle does not start after
the 3rd attempt, the system will abort the remote vehicle start process.
Entering the Vehicle while it is running via Remote Vehicle Start
1. Unlock the vehicle’s doors.
2. Enter the vehicle. DO NOT PRESS THE BRAKE PEDAL!
3. Insert the key into the ignition switch and turn to the ON or RUN position.
4. Press the brake pedal. The remote vehicle starter will disengage and the vehicle will operate normally.