Interlogix TruVision IP Megapixel PTZ Configuration Manual - Manual (Page 29)

2BChapter 3: Camera configuration
TruVision IP PTZ Camera Configuration Manual 25
PTZ parameters
The following sections explain how to configure the different PTZ parameters.
PTZ home position
The initial position is the PTZ home coordinates. It can be the factory default
position or you can customize the initial position to your own requirements.
To set the initial position:
1. In the PTZ folder, click the Initial Position tab to open its window.
2. Click the PTZ control buttons to find a position as the initial position of the
camera. You can also call a defined preset and set it as the initial position.
3. Click Set to save the position.
To call and delete the initial position:
Click to call the initial position. Click to delete the initial
position and restore the factory default initial position.
Basic PTZ parameters
You can configure the basic PTZ parameters, such as proportional pan, preset
freezing, preset speed, keyboard control speed, auto scan speed, and PTZ OSD.
To define basic PTZ parameters:
1. In the PTZ folder (1), click the Basic tab (2) to open its window.
2. Configure the following settings:
Proportional pan: If you enable this function, the pan/tilt speeds change
according to the amount of zoom. When there is a large amount of zoom, the