Interlogix TruVision IP Megapixel PTZ Configuration Manual - Manual (Page 30)

2BChapter 3: Camera configuration
26 TruVision IP PTZ Camera Configuration Manual
pan/tilt speed will be slower for keeping the image from moving too fast on the
live view image.
Preset freezing: This function enables the live view to switch directly from
one scene defined by a preset to another, without showing the middle areas
between these two, to ensure the surveillance efficiency. It can also reduce
the use of bandwidth in a digital network system.
Note: Preset freezing function is invalid when you calling a pattern.
Preset speed: You can set the speed of a defined preset from 1 to 8.
Keyboard control speed: Define the speed of PTZ control by a keyboard as
Low, Normal or High.
Auto scan speed: The camera provides 5 scan modes: auto scan, tilt scan,
frame scan, random scan and panorama scan. The scan speed can be set
from level 1 to 40.
PTZ OSD: Set the on-screen display duration of the PTZ status.
Zoom status: Set the OSD duration of zooming status as 2 seconds, 5
seconds, 10 seconds, Always Close, or Always Open.
PT status: Set the azimuth angle display duration while panning and tilting as
2 seconds, 5 seconds, 10 seconds, Always Close, or Always Open.
Preset status: Set the preset name display duration while calling the preset
as 2 seconds, 5 seconds, 10 seconds, Always Close, or Always Open.
Power-off memory: The dome resumes its previous PTZ status or actions
after it restarts from a power-off. You can set the time point of which the dome
resumes its PTZ status. You can set it to resume the status of 30 seconds, 60
seconds, 300 seconds, or 600 seconds before power-off.
3. Click Save to save changes.
Limit camera movement
The camera can be programmed to move only within a defined area. It is limited
in how much it can move left/right and up/down. This can be useful when you do
not want an area, such as a neighboring building, to be included in the camera
view.
To define the limit stop parameters:
1. In the PTZ folder (1), click the Limit tab (2) to open its window.