Interlogix TruVision IP Megapixel PTZ Configuration Manual - Manual (Page 35)

2BChapter 3: Camera configuration
TruVision IP PTZ Camera Configuration Manual 31
Clear PTZ configurations
Use the PTZ configurations menu to clear all presets, preset tours, shadow tours,
privacy masks, PTZ limits, scheduled tasks, and park actions.
To clear PTZ configurations:
1. In the PTZ folder (1), click the Clear Config tab (2) to open its window.
2. Check the checkbox of the items (3) you want to clear.
3. Click Save (4) to save changes.
Motion detection alarms
You can define motion detection alarms. A motion detection alarm refers to an
alarm triggered when the camera detects motion. However, the motion alarm is
only triggered if it occurs during a programmed time schedule.
Select the level of sensitivity to motion as well as the target size so that only
objects that could be of interest can trigger a motion recording. For example, the
motion recording is triggered by the movement of a person but not that of a cat.
You can define the area on screen where the motion is detected, the level of
sensitivity to motion, the schedule when the camera is sensitive to detecting
motion as well as which methods are used to alert you to a motion detection
alarm.
You can also enable dynamic analysis for motion. When there is motion, the area
will be highlighted in green.
Defining a motion detection alarm requires the following tasks:
1. Area Settings: Define the on-screen area that can trigger a motion detection
alarm as well as the detection sensitivity level.
2. Arming Schedule: Define the schedule which the system detects motion.