Interlogix Topaz User Manual - Manual (Page 104)

Topaz
User Manual
86
How to reset all cardholders
This is used to reset cardholders who have exited the APB area without swiping their cards. This
allows them back into the APB area.
To reset all cardholders in a selected Security area:
1. Click the name of the Security Area in the Reset ALL Cardholders to Security Area list that
you wish to reset.
2. After the name is highlighted, click Reset APB in the top of the Set All Cardholders section.
A message “Operation Complete” displays.
3. Click OK to continue.
For an overview on Anti-Passback, see Appendix C, Anti-Passback .
How to reset selected cardholders
This function enables you to reset the APB of only one cardholder at a time to a selected Security
Area. This is used to allow the specified cardholder who has access to the APB Security Area to be
allowed to re-enter that area after exiting the APB area without swiping their card.
For example, if a cardholder who is in a specified Security Area left the area by tailgating behind
another cardholder and did not swipe their card upon exiting. The Topaz system thinks the
cardholder is still in that area. This allows the security staff to reset that Security Area to allow reentry
for that one cardholder only.
To reset the selected cardholder to a selected Security Area:
1. Click the Cardholder Name in the Available Cardholders list.
2. Click the Security Area the cardholder is to be reset to.
3. After the Cardholder and Security Area names have been highlighted click Reset APB in the
lower Set Selected Cardholder section.
A message “Operation Complete” displays.
For more information on Anti-Passback, see Appendix C, Anti-Passback .