Interlogix Topaz User Manual - Manual (Page 365)

Chapter 12
Troubleshooting, Maintenance, Support
347
Topaz System Error Codes
Error Description
0 No Error.
1 Invalid function number.
2 File not found. Retry the command using the file name.
3 Path not found. Retry the command using the correct path.
4 Too many open files (no handles left). Wait until another program has ended then retry this command.
5 Access denied. The file or disk is read only.
6 Incorrect internal file identifier.
7 The storage control blocks were destroyed.
8 There is not enough memory available to process this command.
9 The storage control block address is invalid.
10 The environment is incorrect.
11 An attempt was made to load a program with an incorrect format.
12 Invalid access code.
13 The data is invalid.
14 The system cannot find the specified disk drive.
16 The disk directory cannot be removed. Remove all files and sub-directories before deleting directory.
17 The file cannot be moved. You cannot move a file to a different drive.
18 No more files.
19 The disk drive is write-protected. Remove write-protect and retry command.
20 Cannot find disk drive specified.
21 Disk drive not ready. Make sure disk is installed and drive light is ready.
22 The device does not recognize the command.
23 Data Error. If the error occurred on the hard disk, retry the command. IF the error occurs again, the hard disk
may have to be reformatted. If the error occurred on a diskette, insert a formatted diskette and retry the
command.
24 The program issued a command but the length is incorrect.
25 Seek Error. The disk may be damaged, unformatted or not compatible.
26 The specified disk or diskette cannot be accessed. Format the disk.
27 Sector not found. The disk may be damaged, unformatted or not compatible.
28 The printer is out of paper or not enough disk space to create a spool file.
29 The system cannot write to the specified drive.