CDA HCG 931 - Manual (Page 11)

11
Installation
Technical Information for the Installer
In order to install the hob into the kitchen fixture, a hole with the dimensions shown in fig. 12 has to be
made, bearing in mind the following:
– within the unit, between the bottom of the hob and the upper surface of a shelf there must be a
clearance of at least 30 mm.
– It is absolutely essential that you place a separator between the base of the hob and the built-in unit or
the oven.
– the hob must be kept no less than 200 mm away from any side wall (fig. 12).
– the hob must be installed at least 60 mm from the wall.
– there must be a distance of at least 650 mm between the hob and any wall cupboard or extractor hood
positioned immediately above (see fig. 14).
– if the hob is installed over a built-in
oven, there must be a distance of
at least 30 mm between the two
appliances. The two appliances
should be connected to the
gas supply with independent
connections
200 mm min
500 mm
450 mm
650 mm
60 mm min
860
480
500
60 min
0
– 2
840
200
min
0
– 2
Installation in Kitchen Cabinet with Door
It is recommended that a 30 mm clearance be left
between the cooktop and the fixture surface (fig. 13).
30 mm
Space for
connections
Clearance
Door
Fig. 12
Fig. 14 Fig. 13