CDA HCG 931 User Manual
Page 12
12
Fastening the Installation Brackets
(fig. 15)
– Each hob is provided with an installation kit including brackets and screws for fastening the top to fixture
panels from 2 to 4 cm thick.
– Turn the hob upside down and fasten the brackets “A” to the appropriate socket holes, without
tightening the screws “B” for the moment (fig. 16).
– Make sure that the brackets are fastened as shown in figure 15.
Fastening the Hob
(fig. 16)
– Spread the sealing material “C” out along the fixture hole, making sure that the junctions overlap at the
corners.
– Insert the hob into the hole and position it correctly.
– Adjust the position of the brackets “A” and tighten screws “B” to block the hob firmly in position.
– With a sharp cutter or trimmer knife trim the excess sealing material around the edge of the hob. Take
care not to damage the benchtop.
A
A
A
A
A
A
C
B
A
Fig. 15
Fig. 16
20 mm min.
40 mm max.