CDA HCG 931 - Manual (Page 13)

13
Gas supply requirements
Important Note
This appliance is supplied for use on NATURAL GAS or LPG (check the gas regulation label attached on
the appliance).
– Appliances supplied for use on NATURAL GAS: they are adjusted for this gas only and cannot be used on
any other gas (LPG) without modification. The appliances are manufactured for conversion to LPG.
– Appliances supplied for use on LPG: they are adjusted for this gas only and cannot be used on any
other gas (NATURAL GAS) without modification. The appliances are manufactured for conversion to
NATURAL GAS.
If the NATURAL GAS/LPG conversion kit is not supplied with the appliance this kit can be purchased by
contacting the After-Sales Service.
Installation and Service Regulations (United Kingdom Only)
This appliance must be installed and serviced only by a suitably qualified and registered person, and in
accordance with the current editions of the following standards and regulations or other locally applicable
regulations:
– Gas Safety (Installation and Use) Regulations
– Building Regulations
– British Standards
– Regulations for Electrical Installation
Installation and service of any gas product must be made by a suitably qualified person competent on
the type of product being installed or serviced and holding a valid certificate of competence for the work
being carried out. Currently the proof of competence is the Accredited Certification Scheme (ACS) or S/
NVQ that has been aligned to the ACS.
It is also a requirement that all businesses or self employed installers are members of a class of person
approved by the Health and Safety Executive.
Failure to install the appliance correctly could invalidate any manufacturers warranty and lead to
prosecution under the above quoted regulation.