ClearSounds A300 - Manual (Page 20)

20 – ENGLISH
NOTE:
If you set the volume to “Off”, when a call comes in,
only the New Call information appears on the LCD and the
phone will not ring.
NOTE:
You can also adjust the ringer volume while you are
receiving an incoming call. Press up or down to
increase or decrease the volume while the phone is ringing.
Visual and Vibrating Ringer
You can activate the visual ringer and vibrating handset
function. A bright LED light will flash and the handset will
vibrate when the phone rings. To turn this feature on/off:
1. In standby mode, press and hold until the icon
appears to activate and press and hold again to
deactivate.
█ Turning the Handset “Power On/Off” Mode
The A300 handset can be turned to “Power Off” mode, which
can be a convenient way to prevent the phone from ringing
without having to change the ringer setting. When you turn the
handset to “Power Off” mode, calls can’t be made or received
until you turn the power back “On”.
In Standby Mode (not during a live call):
1. To turn the handset “Off”, simply press and hold
until the display turns off.
2. To turn the handset “On”, you can either:
a. Place the handset back into the base and the
handset will automatically power on.
b. Press and hold until the display turns on.
█
Using your Phone with Hearing Aids and Cochlear
Implants
Your phone can be used with hearing aids and cochlear implants
equipped with a telecoil (T-coil). Adjust your hearing aid “T-
switch” to the “T” position. Make sure to hold the handset
close to your T-coil.