Clarion CZ500 - Manual (Page 25)

English
Français
Español
Italiano
Español
Español
Español
Español
Español
Car battery
Figure 1
25
9. INSTALLATION/WIRE CONNECTION
GUIDE
1. This set is exclusively for use in cars with a
negative ground 12 V power supply.
2. Read these instructions carefully.
3. Be sure to disconnect the battery terminal before
starting. This is to prevent short circuits during
installation. (Figure 1)
2) Package Contents
3) General Cautions
1. Do not open the case. There are no
user- serviceable parts inside. If you
drop anything into the unit during
installation, consult your dealer or an
authorized Clarion service center.
CONTENTS
1) Before Starting ....................................................................... 25
2) Package Contents ................................................................. 25
3) General Cautions ................................................................... 25
4) Cautions on Installation .......................................................... 26
5) Installing the Source Unit ....................................................... 26
6) Removing the Source Unit ..................................................... 28
7) Wiring and Connections ......................................................... 29
8) Connecting the Accessories .................................................. 30
Source unit ........................................... 1
Front panel ........................................... 1
Trim ring ............................................... 1
Mounting bracket ................................. 1
Screw M5x6 mm .................................. 4
L-key .................................................... 2
Wire connector .................................... 1
Remote control unit (with battery) ........ 1
Owner’s manual ................................... 1
Warranty card ...................................... 1
Microphone .......................................... 1
DCP case............................................. 1
1) Before Starting
2. Use a soft, dry cloth to clean the case.
Never use a rough cloth, thinner,
benzine, or alcohol. For tough dirt,
apply a little cold or warm water to a
soft cloth and wipe off the dirt gently.