Citation Stereo Receiver - Manual (Page 48)

Press the Balance Control button µ and note that an X/Y display will appear on the screen display
(Figure OSD-22). An asterisk will appear at the center of the display to indicate the spot that is the
acoustic center of the room, based on the output level settings established in the Speaker Setup
menus. Note that this
MAY NOT be the physical center of the room, depending on where the listener
making the output level adjustments was positioned.
Figure OSD-22
To move the “center” of the room, press the ⁄ ¤ ‹ › Menu Control buttons . The numbers in paren-
thesis under the indicators for each channel will change to show the exact offset from the true center
(Figure OSD-23) and the asterisk will move to a position following the location of the room’s center.
Figure OSD-23
If no further balance adjustment is required, press the Balance Control button µ twice to return to
normal operation.
Output Level Adjustment Trims
The main output level adjustments for the 5.0 should be made using the internal test tone, follow-
ing the procedures outlined in the section of this manual describing Sound Level Calibration (see
page 35). However, in some instances you may wish to change the levels using an external test
signal generator, a test disc or some familiar piece of audio program material. The 5.0 permits these
adjustments to be made, though they are not recommended as a substitute for initial calibration
using the internal generator.
To trim the output levels using an external source, first follow the procedures outlined for Sound
Level Calibration as shown on page 35. Next, make certain that the proper input source is selected.
To begin the procedure, press the Balance Control button µ twice. The first press will bring up the
standard balance level adjustments. The second press will take you to the Trim Speaker Levels
menu (Figure OSD-24). When the menu appears, use the ‹ › Menu Control buttons to raise or
lower the output level. Note that the changes from the internally-set levels will appear as a positive or
negative offset below the speaker position indicator.
F ( + 1 0 )
*
L
+ R
( + 0 7 ) ( + 0 7 )
B ( + 0 9 )
F ( + 0 0 )
L
* R
( + 0 0 ) ( + 0 0 )
S ( + 0 0 )
48
Operating the Citation 5.0