Appendix a. specifications, Dastape power requirements, Power cable – Certified International DAStape User Manual
Page 45: Appendix a. specifications f
45
Appendix A. Specifications
This appendix contains the following information:
• DAStape Environmental Specifications
• HP LTO Ultrium Generation 1 Specifications
• IBM LTO Ultrium Generation 2 Specifications
• Quantum SDLT 320 Specifications
DAStape Power Requirements
Power requirements for DAStape are summarized in the table below.
Power Cable
The power cable included with DAStape is a standard, three conductor, 18 AWG power
cord safe for 120-volt use in the United States and Canada. The cable has a molded
NEMA 5-15P male connector to plug in the wall and a molded IEC 60320-type female
connector to plug in the DAStape unit.
Note:
To use the DAStape unit outside of the United States or Canada,
the power cord must meet the specifications for that country.
Source
Requirements
Input Voltage
115/230 Volts AC
1.0/.5 A
Input Power
90 Watts minimum
120 Watts maximum
Input Frequency
50/60 Hz