Avaya P460 - Manual (Page 21)

Chapter 3 Avaya P460 Chassis and Module Installation
Avaya P460 Installation and Maintenance Guide 7
Installing the P460 on a Table Top
Place the system on a surface that supports at least 100 lbs (45 kg).
5
Install the supplied rubber feet to the bottom of the switch, placing the feet in
the square recesses provided. See Figure 3.2.
Clean the surface of any oils or residue before applying the feet.
Figure 3.2 Table-Top Installation
6 Ensure that all the preinstalled components are firmly installed in the chassis.
These include:
— Supervisor modules
— Power supply
— Fan module
Caution: Do not place other equipment on top of the P460.
Rack Mounting
Danger: To avoid injury, Avaya recommends that two people to lift the switch onto
a table top. A fully loaded P460 switch weighs at least 100 lbs (45 kg).
You can mount the Avaya P460 in a standard 19" rack either in “front-mount” or
“mid-mount” positions with the brackets supplied with the chassis.
The brackets are symmetric: you can fix either bracket one either side.
Rubber feet