Avaya P460 - Manual (Page 89)

Chapter 13 Maintenance
Avaya P460 Installation and Maintenance Guide 75
Firmware Download CLI Commands
Configuration File Management
You can transfer the Layer 2 parameters to or from the current NVRAM running
configuration file to a TFTP server.
This feature permits you to make a backup of the parameters. You can then use that
file to configure other Avaya P460 switches without re-entering all the parameters
manually.
L To use this feature, you need to have an active tftp server, and to create a file
into which to download the data.
If Avaya MultiService Network Manager is running, you do not require an
additional TFTP server.
Configuration Management CLI Commands
In order to... Use the following command...
Set the default boot bank set boot bank
Download firmware to Bank A copy tftp SW_imageA
Download firmware to Bank B copy tftp SW_imageB
Copy Device Manager (Embedded
Web) firmware copy tftp EW_archive
Show the default boot bank show boot bank
In order to... Use the following command...
Upload the Layer 2 parameters
from the current NVRAM running
configuration to a file via TFTP copy l2-config tftp
Update the Layer 2 parameters in
the current NVRAM running
configuration from a file via TFTP copy tftp l2-config
Show the Layer 2 configuration file show l2-config