Replacing the battery cover, Charging the battery, Replacing the battery cover charging the battery – Samsung Galaxy Avant User Manual

Page 8

Advertising
background image

Section 1: Getting Started

3

Replacing the Battery Cover

► Position the battery cover over the battery compartment and securely press down around the edges until you

hear clicking.

Caution! When replacing the battery cover, do not apply pressure to the screen (“squeeze”) as this can damage

the screen.

Charging the Battery

Your device is powered by a rechargeable Li-ion battery. A wall charger, which is used for charging the
battery, is included with your device. Use only approved batteries and chargers. Ask your local Samsung
dealer for further details.
Before using your device for the first time, you must fully charge the battery.

USB
Cable

Charging Head

Note: Verify that the battery is installed prior to connecting the wall charger. If both the wall charger is

connected and the battery is not installed, the handset will power cycle continuously and prevent proper
operation. Failure to unplug the wall charger before you remove the battery, can cause the device to
become damaged.

Important! It is recommended you fully charge the battery before using your device for the first time.

Note: If the charger is incorrectly connected, damage to the accessory port will occur therefore voiding the

device’s warranty.

To connect a USB cable to the device:

1. Connect the USB cable to the charging head.
2. Locate the Charger/Accessory jack and insert the USB cable into the appropriate jack.

3. Plug the charging head into a standard AC power outlet. The device turns on with the screen locked and

indicates both its charge state and percent of charge.

Warning! While the device is charging, if the touch screen does not function due to an unstable power supply

unplug the USB power adapter from the power outlet or unplug the USB cable from the device.

4. When charging is finished, first unplug the charger’s power plug from the AC wall outlet, then disconnect

the charger’s connector from the device.

5. When charging is finished, first unplug the charger’s power plug from the AC wall outlet, then disconnect

the charger’s connector from the phone.

Important! If your handset has a touch screen display, please note that a touch screen responds best to a light

touch from the pad of your finger or a non-metallic stylus. Using excessive force or a metallic object
when pressing on the touch screen may damage the tempered glass surface and void the warranty.

Advertising