KERN & SOHN GAB 30K5DNM - Manual (Page 25)

GAB-N-BA-e-1315 25
10.4 Parts counting
Before the balance can count parts, it must know the average part weight (i.e.
reference). Proceed by putting on a certain number of the parts to be counted. The
balance determines the total weight and divides it by the number of parts (the so-
called reference quantity). Counting is then carried out on the basis of the calculated
average piece weight.
The higher the reference quantity the higher the counting exactness.
(example)
 Place the reference quantity
 Press
F
C
, the scales will change to quantity counting mode
Reference quantity of 10, P 10 will appear.
 Reference quantities of 10, 20, 50, 100 and 200 can be set
by pressing
TARE
.
(example)

GROSS

GROSS
pcs
 Confirm by pressing
0
You will briefly see a line on the screen before the scales
show the respective quantity
 To change between reference weight, total weight and
quantity, press the key.
 To return to weighing mode, press the
F
C
key.