Malone MPG460G 2011 - Manual (Page 16)

MPG460G
800-295-0042 ext 206
[email protected]
16
9. Press the brown wire into the quick connec-
tor as shown. Then insert the wire from the side
marker light fully into the 2nd opening. Use pliers
to squeeze the conductor blade down and thru the
insulation. The blade cuts thru the insulation and
connects the wires inside. Flip the cover to lock
the connector. Repeat on the other side again us-
ing the brown wire.
12. There are holes in the back side
of each lamp marked by wire
color. Identify which hole is for
which color wire. Then careful-
ly push the twisted wire straight
into the corresponding hole.
You will feel the wire slide under
the wire gripper inside the lamp
as you push the wire into it.
Once the wire is pushed in it will
not come back out. Tug gently
to check for a good connection.
Repeat on the other side.
11. Strip 1/2” of insulation off the ends of
all 4 tail light wires. Twist the exposed
copper strands to stiffen them.
10. Route the wires to the rear along
the frame. Exit the frame via the slot-
ted hole under the lamp bracket. Use
wire clips to secure the wires. Bring the
wires to the tail lamps, add 10 inches
more to serve as extra length for service
work, and cut there. Coil the extra.