Malone MPG460G 2011 - Manual (Page 5)

800-295-0042 ext 206
[email protected]
5
MPG460G FRAME ASSEMBLY (Group 1)
1. We assemble the frame on its back to make it easier to install the springs
and axle. Once the springs and axle assembly is installed we will fl ip the trailer
over to complete the assembly. So fi rst, layout the frame components upside
down as shown. The spring bracket mounting holes should be facing up. All
the decals should be upside down.
2. Attach the spring
hanger brackets to the
frame. The U shaped
shackle bolt brackets
mount to the front and
the C shaped “slip-
per” brackets mount
to the rear as shown.
Use 3/8” x 1” bolts and
nuts. Assemble with
the nuts on the inside of the frame rails. Fully tighten all 8 bolts now.
3. Identify the hitch end of the tongue
by the 3 holes on the left side. Insert
the small wire protection grommet
into the lower hole where shown,
then push it all the way in till it snaps
in place.