Malone MPG460G 2011 - Manual (Page 20)

MPG460G
800-295-0042 ext 206
[email protected]
20
3. Place the skid and chain as-
sembly under the tongue and
insert the bolt up through the
skid bolt hole on the bottom of
the tongue as shown.
4. Slip the ring terminal over
the bolt and install the nylon
lock nut hand tight.
5. Check that the rear end of
the skid is still in its hole in the
bottom of the tongue. Tighten
the bolt while holding the nut
stationary. This way the ring terminal remains straight.
6. Install the coupler and
coupler handle onto the
tongue as shown. Then
tighten until the coupler
fi rmly grips the tongue.
Don’t over tighten and crush
the tongue.