MF Digital CD-5916 (Rev: 03/05/01) - Manual (Page 19)

CD-5916
Operator’s Guide
Document Revision: 060102
Page 18
•
Press the “START/YES” key to “enable” or the “STOP/NO” key to
“disable” the Full Scan feature. After pressing either key, the screen
will now read:
V E R I F Y A F T E R O P T I O N
P R E S S Y E S / N O
The factory setting for this function is “disabled”. When “enabled”,
the Verify After feature automatically compares discs to the master
disc or hard disk image after copying is completed. Due to the nature
of the various compact disc formats, only CD-ROM Mode 1, CD-
ROM Mode 2, CD-ROM XA Mode 2 Form 1, and audio (CD-DA)
discs can be compared.
•
Press the “START/YES” key to “enable” or the “STOP/NO” key to
“disable” the Verify After feature. After pressing either key, the
screen will now read:
A R C H I V E O P T I O N
P R E S S Y E S / N O
The factory setting for this function is “enabled”. When “enabled”,
the Archive feature allows copies of master discs to be stored on the
CD-5916’s internal hard disk for later recording or comparing (see
page 25). This setting will remain in effect until “disabled”, even
after restarting the CD-5916.
•
Press the “START/YES” key to “enable”, or the “STOP/NO” key to
“disable” the Archive feature. After pressing either key, the screen
will now read:
M U L T I P L E I M A G E S
P R E S S Y E S / N O
The factory setting for this function is “disabled”. When “enabled”,
the Multiple Images feature allows up to six images to be stored on
the hard disk drive at one time (see page 24). This setting will remain
in effect until “disabled”, even after restarting the CD-5916.
•
Press the “START/YES” key to “enable” or the “STOP/NO” key to
“disable” the Multiple Images feature. After pressing either key, the
screen will now read:
R E C O R D R I D O P T I O N
P R E S S Y E S / N O
The factory setting for this function is “disabled”. When “enabled”,
the Record RID feature will write SmartRID and SmartSTAMP
codes into audio and data discs copied by the CD-5916 (see page 41).