MF Digital CD-5916 (Rev: 03/05/01) - Manual (Page 44)

CD-5916
Operator’s Guide
Document Revision: 060102
Page 43
ATIP Codes
ATIP stands for “Absolute Time In Pre-Groove”. In firmware 7.0XX and
higher, the ATIP option allows you to determine the manufacturer of the
disc placed in the top drive of the CD-5916. It will also determine the
minutes, seconds, and frames present on the disc. Many generic brand CD’s
will not be recognized.
Reading ATIP Codes
To read an ATIP Code from a disc, the steps are as follows:
•
From the main operating screen depicted below:
. 1 6 X C O P Y O R C O M P A R E
•
Place the disc that you wish to read the ATIP information from, into the
top drive of the CD-5916.
•
Press the “7” key. The screen will now read:
E N T E R A U T H O R I N G M O D E
•
Press the “STOP/NO” key. The screen will now read:
R E A D R I D I N F O ?
•
Press the “STOP/NO” key. The screen will now read:
R E A D A T I P ?
•
Press the “START/YES” key. The screen will now read:
R E A D I N G A T I P C O D E
WA I T I N G F O R D R I V E S R E A D Y
•
The screen will now display something similar to this.
A T I P C O D E 9 7 m 2 7 s 5 5 F
P R E S S S T A R T
•
Press the “START/YES” key. The screen will now display something
similar to this.