Microtel CellStat v.1.22 - Manual (Page 20)

MICROTEL CellStat
TM
18
The CellStat
TM
features true modularity—Fault input channels operate completely
independently of each other. Using the following commands, each Fault Input in your
dialer can be configured to operate uniquely to satisfy your application requirements. For
each Fault Input, record a voice message, program an alarm integration delay, and define
the input channel’s normal (non-alarm) state.
z I/O Channel Voice Name An individual I/O channel’s spoken voice name.
*c1 Play I/O channel c voice name
**c1~ Record I/O channel c voice name
NOTE: User cannot record a voice message for the Power Fault channel 5
Sample Message- Channel one normally open digital input.
A new channel name can be recorded with the '**c1' command. Once the command
is typed record your voice message after the dialer prompts you “Ready”. A
maximum of 6 seconds of recording time is allowed for each fault input message.
z I/O Channel Fault Delay When channel c changes state, this timer delays an alarm
until the channel has been in the alarm state for (SS) seconds. This parameter will
filter out noisy, or temporary, state changes from placing undesired nuisance alarm
calls. During this fault delay period, the corresponding CH LED indicator will turn
yellow, indicating that the input channel is NOT in its normal state, but has not been
in the state long enough to cause an alarm callout. After the delay has elapsed, and
the fault state condition still exists, the corresponding CH LED will turn RED and
begin flashing.
*c2
Report I/O channel c delay
**c2SS Program I/O channel c delay
Example- Command: **1230
Response: Channel one fault delay is three zero seconds.
z I/O Alarm Configuration Selection of channel c normal state (OPEN or
CLOSED)
*c3
Review I/O channel c alarm configuration
**c31/0 Program I/O channel c alarm configuration
Example- Command: **131
Response: Channel one normal state is open
NOTE: If C=5, the Power Fault channel, the response is:
Example Command: **531