Microtel Series 1000 - Manual (Page 33)

MICROTEL Series 1000 Dialer
27
As described in the theory of operation in Chapter 1, the dialer can store up to nine (9)
phone numbers in the System Telephone Directory. This section explains how to
program the dialer’s telephone numbers and shows how to customize the numbers for
certain call-out situations.
Use the following command to enter each telephone number into the Series 1000 dialer:
*01n
Review Telephone n (n=1 to 9)
**01np** Program Telephone n (n=1 to 9)
p = telephone number of up to 60 digits with escape codes for one of 9 (nine) telephone
numbers. The telephone data is terminated with ‘**’ (two asterisks).
Example- Command:
**0112760571**
Response: Telephone number one is two seven six zero five seven one
Example- Command:
**0152432400**
Response: Telephone number five is two four three two four zero zero
These phone numbers may be customized to use the Call Progress features of the dialer.
Refer to the Advanced Topics chapter for a full discussion about using these powerful
features of the Series 1000 Dialer.