Microtel Series 1000 User Manual
Page 52
MICROTEL Series 1000 Dialer
46
Example 4- Program phone number 4
|
To send a Fax report
| | To
555-1212
| | | Terminate
telephone
entry
| | | |
Command:
**014
*991
5551212
**
Response:
Telephone number four is STAR nine nine one five five five one two one
two.
The *991 escape sequence shown must be embedded within telephone numbers
calling to FAX machines. This tells the dialer to begin to generate a FAX report
before it goes off-hook and dials the remote machine. Always put the *991 sequence,
as well as any other non-call progress sequences (such as auto acknowledge), at the
beginning of the telephone number string before the dialer goes off-hook to dial
regular telephone digits.
Example 5-
Program phone number 2
|
No Voice Message (Pager)
|
|
Auto acknowledge call
|
|
|
Dial Pager Terminal (Example Phone #)
|
|
|
|
Wait 30 seconds for Answer
|
|
|
|
|
Wait 4 Seconds After Answer
|
|
|
|
|
|
Dial No. for pager
|
|
|
| |
|
| Dial
a
‘*’
|
|
|
| |
|
| |
Dial
Current
Alarm
|
|
|
| |
|
| |
|
Dial
‘*’
|
|
|
| |
|
| |
|
|
Dial
All
Alarms
|
|
|
|
|
|
|
|
|
|
| Termination
|
|
|
| |
|
| |
|
|
|
|
Command:
**012 *940 *90 5551212 *730*4 *2*2 5556565 *91
*984 *91
*985 **
This example illustrates using the Automatic Current Alarm Display feature with a
pager system. When the escape code *984 is embedded within a telephone number, it
causes a single digit (‘0’-’9’) according to the current alarm to be dialed. Thus, when
dialing a numeric pager, the actual alarm index can be included in the page. Insert
this code after the telephone number that is sent to the paging terminal. Use a ‘*’ key
to indicate that the following digit is the alarm index. The escape code *985 is used
to show all current alarms on the system.
If channel 4 was the current channel in alarm and channels 6 and 7 are also in alarm
when the page is sent, it will read ‘5556565*4*467’ when you get your message.
NOTE: Some pagers do not accept the ‘*’ (*91) or ‘#” (*92) dtmf tones as input. Also,
some require the ‘#’ (*92) to terminate the input sequence. See pager system
documentation for details.