Citizen Systems CBM-270 - Manual (Page 86)

CBM-270 User’s Manual
[Code] <1D>H<3C>H
[Outline] This command initializes the printer mechanism.
[Caution] This command is valid only when the label printer is selected with DS1-5. Since it uses one
label for scanning, a head search starts from the next label. The maximum label length and
label spacing (Black mark) is 300 mm. Any label exceeding this limit results in an error.
GS A m n (Only When Label Printer is Selected)
[Function] Correctting the label top position
[Code] <1D>H<41>H<m><n>
[Range] 0
≤
m
≤
255, 0
≤
n
≤
10
[Outline] This command sets the label head search position in terms of correction value for the default
position. m denotes the correcting direction and valid only for the least significant bit (m0).
m 0 Correcting direction
0 Corrects in the forward direction
1 Corrects in the reverse direction
n denotes a correction value; it is set in increments of n/203 inch.
[Caution] This command is valid only when the label printer is selected with DS1-5. The correction
value remains valid until it is re-set with this command or the power is turned on again. Any
setting beyond the range is ignored.
11. CHARACTER CODES TABLE