Canon IMAGE FORMULA DR-6010C - Manual (Page 29)

Chapter 2 Setup
2-14
2-5 Turning the Power ON
When you turn the computer and the scanner ON, the Plug and Play function of Windows
recognizes the scanner and automatically installs the required device driver.
IMPORTANT
• When connecting the scanner to the computer using a SCSI cable, be sure to turn power to
the scanner ON first, and then turn power to the computer ON. If you turn power to the
computer ON first, the scanner may not be properly recognized by the computer.
• If you turn the power OFF, wait at least 10 seconds before turning it ON again.
• If you will not be using the scanner for an extended period, you should disconnect the power
cord from the AC outlet for safety.
Scanner Recognition
The scanner will be recognized the first time it is connected to the computer.
1
Make sure that the scanner and computer are connected properly.
2
Press the power switch to turn the scanner ON.
The power indicator lights green.
3
Turn the computer ON.
4
Log onto Windows with an account that has Administrator privileges.
5
Windows recognizes the DR-6010C automatically, and installation of the device driver begins.
Windows Vista
Windows 2000
Windows XP
Power switch
Power indicator
ON