About launcher, About launcher -12, See “about – Canon IMAGE FORMULA DR-6010C User Manual
Page 42: Launcher,” on p. 3-12.)
Chapter 3
Basic Operation
3-12
About Launcher
To use the Launcher feature, it is necessary to first change the Windows event settings as described
below, and specify an application for each job button.
Note
• By default, all applications supporting the event function are enabled. If you do not change
the event setting before you use the Launcher feature of the DR-6010C, the dialog box
shown below will appear. Select an application from this dialog box or click [Cancel] and
change the event settings.
• Only applications that support the Windows event function can be started using the
Launcher feature of the DR-6010C.
• Some applications may not work correctly if started using the Launcher feature.
Event Settings
This section describes how to change the Windows event settings.
1
Open the [Event settings] dialog box.
1. Click [Start] - [Control Panel] to open the Control Panel.
Note
Under Windows 2000, click the [Start] button and select [Settings] - [Control Panel] to open
the Control Panel, then proceed to step 3.