PRG VL6C+ User Manual
Page 33
VL6C+ ™ SPOT LUMINAIRE USER MANUAL
25
Connect Series 300 Modular Rack to power source:
Three-phase power will need to be supplied to the system. The maximum recommended Modular Rack power
requirement is 200 amps, using 2/0 feeder with 4/0 Cam-Lok connectors and a 200A line disconnect. A SixPack
Chassis requires 30 amps, and uses Hubbell or Epic connectors on 8/5 multicore cable. Connector choice is
dependent upon location. This cable will need to be run from a house disconnect through a 30A line disconnect to the
racks.
WARNING:
The high voltages required to run this equipment are dangerous. Electrical "tie-ins" should be
handled by a qualified electrician.
Note: Some equipment in Europe will work using single-phase power. Check with an Account Manager regarding
your event.
Figure 2-9: Power and Data Configuration (Typical)
Power Input
VL6C+
VL6C+
Series 300 Smart Repeater
or Smart Repeater Plus Unit *
FRONT
REAR
FRONT
SIDE
Series 300 Lamp Run
(Lamp Power)
A maximum of three (3) VL6C+ Luminaires may be
powered from a Smart Repeater unit and a maximum
of six (6) VL6C+ Luminaires from a Smart Repeater
Plus unit.
Series 300
APS Trunk Cable
*
120/208 Volt
3Ø AC Line
Series 300 Modular Rack
w/ APS6 Power Supply Modules
AC Power
DMX512 From Console