Replacing a standard gobo or color filter – PRG VL6C+ User Manual
Page 54
46
VL6C+ ™ SPOT LUMINAIRE USER MANUAL
Replacing a Standard Gobo or Color Filter
Parts:
Standard Gobo or Color Filter, as required
Tools:
Screwdriver, #2 Phillips
WARNING:
Remove power from luminaire before performing any maintenance procedures.
To remove and replace a standard gobo or color filter:
Step
1. Remove power from luminaire.
Step
2. At head assembly, turn two captive screws one-quarter turn and remove cover (it will remain attached by
tether). (Figure 4-3.)
Step
3. In some cases it is easier to slide the color/gobo bulkhead partially out of the head assembly to access
gobo and color filters. If required, do the following:
a.
At Yoke Termination PCB, disconnect cables at locations J10-J17. (Cables are labeled for easy re-
connection.)
b.
At color/gobo bulkhead, turn captive screw one-quarter turn to release bulkhead.
c.
Remove bulkhead from head assembly.
Figure 4-3: Removing Color/Gobo Bulkhead
Step
4. If not removing color/gobo bulkhead, simply rotate wheel until gobo or color filter is accessible.
Captive Screw
Color/Gobo Bulkhead
Cover
Head Assembly
Removable
Captive Screw (2)